PENAMBAHAN SERBUK LIMBAH KACA DAN ABU DAUN BAMBU TERHADAP KINERJA PAVING BLOCK
Abstract
Glass is an object that cannot be separated from human life. Based on data from the Minister of Environment and Forestry (LHK) in 2020, it was stated that data on waste in Indonesia reached 67.8 million tons, of which 0.7 million tons were glass waste. It is known that the types of waste produced in Indonesia are organic waste (60%), plastic waste (14%), paper waste (9%), metal (4.3%), glass and wood (12.7%). The purpose of this study was "to know the effect of adding glass waste powder and bamboo leaf ash on the performance of paving blocks". The data needed in this study are primary data and secondary data. The technique used to collect primary data in this research is the experimental method. The data to be analyzed was obtained from the results of testing in the laboratory using 45 samples. Data were analyzed using multiple linear regression test. All analysis using SPSS software which is then presented in the form of tables, pictures and descriptions. The results showed that the average compressive strength of paving blocks was B quality with regression equation Y = 19.010+ (-0.119) X1 + (0.063) X2, while for absorption was D quality with regression equation Y = 10.598+ (-0.094) X1 + (-0.001) X2. In general, the addition of glass waste and bamboo leaf ash has an effect on the compressive strength and water absorption of paving blocks.
References
Aliabdo, A. A., & M. Elmoaty, A. (2016). Utilization of Waste Glass Powder in The Production of Cement and Concrete. Construction and Building Materials, 124, 866-877.
Anonim. (1996). SNI 03-0691-1996 tentang Bata Beton (Paving Block). Jakarta: Badan Standarisasi Nasional.
Anonim. (2002). Metode Pengambilan Contoh dan Pengujian Abu Terbang atau Pozolan Alam Sebagai Mineral Pencampuran dalam Beton Semen Portland. Jakarta: Badan Standarisasi Nasional.
Anonim. (2004). Semen Portland. Jakarta: Badan Standarisasi Nasional.
Anonim. (2008). SNI 1970 : 2008 tentang Pengujian Berat Jenis dan Penyerapan Air Agregat Halus. Jakarta: Badan Standarisasi Nasional.
Anonim. (2012). SNI ASTM C136 tentang Pengujian Analisa Saringan Agregat Halus dan Agregat Kasar. Bandung: Badan Standarisasi Nasional.
Diana, A. I., Fansuri, S., & Deshariyanto, D. (2020). Penambahan Abu Daun Bambu Sebagai Substitusi Material Semen Terhadap Kinerja Beton. PADURAKSA, 9 (2), 172-182.
Du, H., & Tan, K. H. (2014). Waste Glass Powder as Cement Replacement in Concrete. Journal of Advanced Concrete Technology, 12, 468-477.
Harrison, E., Berenjian, A., & Seifan, M. (2020). Recycling of waste glass as aggregate in cement-based materials. Environmental Science and Ecotechnology, 1-8.
Islam, G. S., Rahman, M., & Kazi, N. (2017). Wate Glass Powder as Partial Replacement of Cement for Sustainable Concrete Practice. International Journal of Sustainable Built Environment, 6, 37-44.
Karwur, H. (2013). Kuat tekan beton dengan bahan tambah serbuk kaca sebagai substitusi parsial semen. Jurnal Sipil Statik, 1 (4).
Khan, M. N., Saha, A., & Sarker, P. (2019). Reuse of Waste Glass as A Suoplementary Binder and Aggregate for Sustainable Cement Based Construction Materials : A Review. Journal of Building Engineering.
Safri, M. R. (2019). Pengaruh Penggunaan Abu Bambu Sebagai Substitusi Parsial Semen Terhadap Kuat Tekan Beton . Sumenep: Program Studi Teknik Sipil Fakultas Teknik Universitas Wiraraja.
Samekto, W., & Rahmadiyanto, C. (2001). Teknologi Paving Block. Yogyakarta: Kanisius.
Siregar, S. (2012). Statistik Parametrik untuk Penelitian Kuantitatif. Jakarta: Bumi Aksara.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
![](/public/statistik.png)
![](/public/pdf.png)